Magmaweld MPM 20/500 Y Welding Generator
Category
:
Welding Generator
Product Code
:
Magmaweld MPM 20/500 Y Welding Generator
- It is powered by a water-cooled diesel engine and, in addition to its built-in welding function, provides 400 V/50 Hz (3-phase) and 230 V/50 Hz (3-phase) auxiliary outputs for external use.
- In addition to successful welding with rutile, basic, and cellulose-coated electrodes, it offers Lift-TIG and carbon arc cutting capabilities. With the optional wire feeder unit, it enables MIG/MAG welding.
- The welding current can be adjusted via the potentiometer on the front panel and the remote control box with a 20-meter cable.
- Indicators for current, voltage, fuel level, and operating time are located on the front panel.
- It is specifically designed for outdoor use and has an IP23S protection rating. There is no loss of performance with long welding cables.
- It is compatible with a specially designed wheeled trailer (optional).
- It operates with a 12-volt internal battery and automatically switches to idle when there is no load.
- It features warnings for low fuel level, low oil pressure, and battery charging failure. It is equipped with ground fault and overheating protection.
- Electrode and ground clamps are included as standard.
| Engine | ||||
| Type | Yanmar 4TNV98 | |||
| Power | 46.1 | HP | ||
| Total Cylinder Displacement | 3,319 | cm³ | ||
| Number of Cylinders | 4 | |||
| Cooling System | WATER | |||
| Operating Type | ELECTRIC | |||
| Fuel Consumption | 6.4 (75%) | lt/hr | ||
| Fuel Tank Capacity | 70 | L | ||
| Dimensions (L x W x H) | 2015 x 900 x 1300 | mm | ||
| Weight (Net) | 975 | kg | ||
| Generator | ||||
| Maximum Power (1-Phase) | 6.6 kVA – 230 VAC | |||
| Maximum Power (3-Phase) | 20 kVA – 400 VAC | |||
| Power Factor | 0.80 | |||
| DC Source Circuit | ||||
| Rated Welding Current | 500 A at 60% (40 V) | ADC | ||
| Rated Source Current | 400 A at 100% (36 V) | ADC | ||
| Open-Circuit Voltage | 70 | V | ||
| Electrode Diameter | 2.00–6.00 | mm | ||
| Maximum Carbon Cutting Electrode | 10 | mm | ||
To leave a review, you must be logged in and have purchased the product.*